SIIG, INC.

E-LAN 100

Card Type              Network Interface Card
NIC Type               Ethernet
Maximum Onboard Memory 16KB
Boot ROM               Available
Network Transfer Rate  10Mbps
Topology               Linear Bus
Wiring Type            AUI transceiver via DB-15 port

                       RG-58A/U 50ohm coaxial
Data Bus               8-bit ISA

[Image]

                                CONNECTIONS

         Function            Label           Function            Label

  AUI transceiver via         CN1       RG-58A/U connector        CN2
  DB-15 port

                        USER CONFIGURABLE SETTINGS

                  Function                      Label        Position

  »   Boot ROM disabled                         J5/A           Open

      Boot ROM enabled                          J5/A          Closed

                           ROM ADDRESS SELECTION

     Address        J5/B        J5/C       J5/D        J5/E       J5/F

  »     C000h      Closed      Closed     Closed      Closed     Closed

        C200h       Open       Closed     Closed      Closed     Closed

        C400h      Closed       Open      Closed      Closed     Closed

        C600h       Open        Open      Closed      Closed     Closed

        C800h      Closed      Closed      Open       Closed     Closed

        F600h       Open        Open      Closed       Open       Open

        F800h      Closed      Closed      Open        Open       Open

        FA00h       Open       Closed      Open        Open       Open

        FC00h      Closed       Open       Open        Open       Open

        FE00h       Open        Open       Open        Open       Open

                                   Note:

  A total of 32 address settings are available. The switches are a binary
  representation of the decimal memory addresses. Switch J5/F is the Most
  Significant Bit and switch J5/B is the Least Significant Bit. The
  switches have the following decimal values: J5/F=4096, J5/E=2048,
  J5/D=1024, J5/C=512, J5/B=256. Turn off the switches and add the values
  of the switches to obtain the correct memory address. (Open=1,
  Closed=0)

                                   Note:

  Do not use the following addresses in AT systems: C000h-C600h, and
  E000h-F400h.

                                   Note:

  Do not use the following addresses in XT systems: C800H, and CA00h.

                        BASE I/O ADDRESS SELECTION

             Setting                      J4/A                J4/B

  »              300h                    Closed              Closed

                 320h                     Open               Closed

                 340h                    Closed               Open

                 360h                     Open                Open

                           CABLE TYPE SELECTION

     Setting      J3/A    J3/B    J3/C    J3/D    J3/E    J3/F    J3/W1

  »   BNC         Pin 1   Pin 1   Pin 1   Pin 1   Pin 1   Pin 1   Closed
      enabled      & 2     & 2    & 2     & 2     & 2     & 2

      AUI         Pin 2   Pin 2   Pin 2   Pin 2   Pin 2   Pin 2    Open
      enabled      & 3     & 3    & 3     & 3     & 3     & 3

  Note: Designated pins are closed.